Speed limiter proposed

The National Highway Transportation Safety Administration and Federal Motor Carrier Safety Administration are proposing regulations that would require vehicles with a gross vehicle weight rating of more than 11,793.4 kilograms (26,000 pounds) to be equipped with a speed limiting device initially set to a speed no greater than a speed to be specified in a final rule and would require motor carriers operating such vehicles in interstate commerce to maintain functional speed limiting devices set to a speed no greater than a speed to be specified in the final rule for the service life of the vehicle.

Specifically, NHTSA is proposing to establish a new Federal motor vehicle safety standard (FMVSS) requiring that each new multipurpose passenger vehicle, truck, bus and school bus with a gross vehicle weight rating (GVWR) of more than 11,793.4 kilograms (26,000 pounds) be equipped with a speed limiting device.

The proposed FMVSS would also require each vehicle, as manufactured and sold, to have its device set to a speed not greater than a specified speed and to be equipped with means of reading the vehicle’s current speed setting and the two previous speed settings (including the time and date the settings were changed) through its On-Board Diagnostic connection.

FMCSA is proposing a complementary Federal motor carrier safety regulation (FMCSR) requiring each commercial motor vehicle (CMV) with a GVWR of more than 11,793.4 kilograms (26,000 pounds) to be equipped with a speed limiting device meeting the requirements of the proposed FMVSS applicable to the vehicle at the time of manufacture, including the requirement that the device be set to a speed not greater than a
specified speed. Motor carriers operating such vehicles in interstate commerce would be required to maintain the speed limiting devices for the service life of the vehicle. Based on the agencies’ review of the available data, limiting the speed of these heavy vehicles would reduce the severity of crashes involving these vehicles and reduce the resulting fatalities and injuries. We expect that, as a result of this joint rulemaking, virtually all of these vehicles would be limited to that speed.

You’re invited to comment. Submit your comments early enough to ensure that the docket receives them not later than November 7, 2016. ADDRESSES: You may submit comments, identified by one or both of the docket numbers in the heading of this document, by any of the following methods:

  • Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the online instructions for submitting comments.
  • Mail: Docket Management Facility: U.S. Department of Transportation, 1200 New Jersey Avenue SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-0001
  • Hand Delivery or Courier: 1200 New Jersey Avenue SE., West Building Ground Floor, Room W12-140, between 9 a.m. and 5 p.m. ET, Monday through Friday, except Federal holidays.
  • Fax: 202-493-2251.

Refer to Docket FR Doc. 2016-20934.

This entry was posted in regulations, safety, truck driving and tagged , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>